Honne grinder near-zero retention

-

 


Reacties

Steve zei…
Thanks for posting this video. I’ve been pondering buying one of these grinders to replace my Titus modified Versalab M3 for some time. Ultimately, I’m put off by a number of things; aside from the very slow response to customer service queries from Hedone, the portafilter holder design doesn’t seem that well suited to the offset lug portafilter design on the Londinium. On my Versalab, I glued rubber strips to the tops of the arms of the portafilter, holder enabling it to grip the portafilter and not allow it shake free whilst grinding hands free. I know Reiss has modified his arms with some angled extrusion. Have you modified your Hedone to grip your Londinium portafilter?
7 augustus 2023 om 04:32
Frans zei…
Thankyou! I added just two small strips of gaffer tape and that seems to prevent slipping of lugs well



My two different Londinium LR24 and Vectis naked portafilters fit well.
7 augustus 2023 om 04:48
Steve zei…
I’m not sure if my reply got through, so here’s a second go.
Thanks for your info. Two final questions, where did you get the small rubber hammer from and where did you get the shot mirror from?

Thanks

Steve
7 augustus 2023 om 06:07
Frans zei…
I can read it now!
The hammer is from alibaba
A friend here in The Netherlands assembled the shot mirror grom very cheap parts he sourced from different shops, some online.
7 augustus 2023 om 06:47
Frans zei…
AliExpress gevonden
Taylor Neurologische Medische Massage Knie Schok Percussor Reflexen Diagnostische Percussie Tool Buck Zenuwonderzoek Reflex Hamer
https://a.aliexpress.com/_EIGiYnd
7 augustus 2023 om 07:55
Een reactie posten

Populaire posts van deze blog

Finished Pavoni & Fuji PXG4 pid: Probe Inside the Ring

-
Afbeelding
Delicious cup: all the work was well invested! At the end of the previous blog about the pressostat and PID working together , I mentioned that I would like to clean up the xmas tree of wires and have as few cables and probes as possible to visually disturb the classic design of the La Pavoni. Getting rid of the probe that was fastened with copper tape to the top of the brew group was a priority. I wanted to hide a new probe in the cooling fin as close as possible to the brew group. This morning I asked Tije if he could do that. He would need to drill a straight hole of 3mm diameter in the 4mm inner ring of the cooling fin that sits as a tight clamp around the brew group. Always the optimist, Tije set to work: First, Tije made a piece of aluminum to fit the inside of the ring. Drilling a thin hole straight through the curved aluminum, if possible tangentially going through the inside of the ring to touch the brew head directly, you need the support of the temporary insid...
Meer lezen